Adjustable Blade Clipper

ELECTRIC CLIPPER

1. Put a small drop of clipper oil between the blades after each use. Oil should be applied while the clipper is running. After cutting wet hair, clean the blades and apply a small drop of clipper oil. Apply the oil after each use. 2. Blades must be realigned if they have been removed for cleaning or replacement. 3. Streaks and missing hair are caused by a gummy sticky surface on the blades, so keep your clipper clean and the blades well oiled. 4. Clattering when turning the clipper on or off may occur on some clippers. It is of no consequence. The same is true if your clipper heats up after 20-25 minutes of use. 5. Make sure cord is not twisted or kinked while unit is charging or being stored. 6. To clean the unit, use either a clean, dry or dampened cloth. DO NOT USE benzene or thinner to clean the unit.

CORD

If your clipper has a polarized plug: To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug fits in a polarized outlet only one way. In the event the plug does not fit fully in the outlet, reverse the plug. In the event it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

TAPER LEVER

The RED clipper is equipped with an adjustable taper lever that changes the closeness of your cut. When the lever is in the uppermost position, the blades will give the closest cut. Pushing the lever downward gradually increases the cutting length.

POWER SCREW 

To adjust power, turn power screw in clockwise direction until clipper makes a noise caused by the armature hitting the coil. Then, slowly turn power screw out (counter-clockwise) just until noise stops. This is maximum power.