Complete Acrylic Kit

Use in a well ventilated area and always protect work surface with several layers of paper towels.

Preparing your nails:

Clean nails of any polish or oils with an acetne-based nail polish remover. Trim and file your nails. Push back cuticles with manicure stick. Gently buff entire nail surface using buff block to ensure maximum adhesion.

Tip Selection:

1. If needed, file sides of artificial tip for a customized fit.

2. Apply a drop of Nail Glue to the tip of the natural nail. Align the edge of well area of artificial tip onto free edge of natural nail at an angle and press down onto nail. Hold firmly for 5 seconds. Make sure there are no visible air pockets in bonding area.

3. Trim and file artificial tip to desired length and shape. Carefully file top of artificial nail to blend seam with natural nail. Avoid over-filing, which could damage the natural nail

Acrylic Application:

1. Apply nail primer sparingly to natural nail surface, avoiding skin and cuticles.

2. Carefully pour acrylic liquid into dappen dish. Dip brush into liquid and wipe brush onto paper towel to soften bristles.

3. Dip brush bristles halfway into acrylic liquid and then slowly drag the tip of the brush across the acrylic powder's surface until a small bead forms at the end of the brush.

4. Place acrylic bead onto nail near cuticle. Use the body of the brush to gently pull down on the bead, and with a patting motion, gently press to spread and thin out the overlay.

5. Repeat step 4 until the entire nail and tip are covered, and the acrylic surface is leveled and has a desirable shape. Remove any acrylic that gets on your cuticle or skin with manicure stick.

6. Allow acrylic to harden for 3-5 minutes. Tap the nail surface with a manicure stick. A sharp “clicking" sound means the overlay is dry.

7. File entire nail surface with using Kiss® Professional Nail File to even overlay surface.

8. Use Kiss®White Buff Block to smooth and finish.

9. Apply polish.

Acrylic Sculpting:

1. Place adhesive sculpting form underneath nail's free edge in place of a tip to extend length. Pinch sides of form flush around fingertip and against free edge.

2. Following acrylic application steps 1-4, apply acrylic bead onto form at desired length. Flatten the bead and shape sides of extension with the body of the brush until mixture begins to cure.

3. Continue with steps 6-9 from Acrylic Application.

How to Remove:

1. Do not force, pry or pull nails off.

2. Trim as much nail length off as possible and soak in an acetone-based polish remover for approximately 20 minutes, continuously wiping nail surface on paper towels untiI overlay melts off completely.

Tips: ABS Plastic

Acrylic Liquid: Ethyl Methacrylate, HEMA, Glycol Dimethacrylate, Hydroxyethyl Methyltolylamine, Benzophenone-3, Hydroquinone, Violet 2 (CI 60725)

Acrylic Powder: Polyethylmethacrylate, Acrylates Copolymer, Benzoyl Peroxide, Water (Aqua), PEG-12 DimethiconeAcrylic Primer: Acetone, Bis(Glyceryl Dimethacrylate) Pyromellitate, Glyceryl Dimethacrylate

Glue: Ethyl Cyanoacrylate, Polymethyl Methacrylate, Sulfur Dioxide

Acrylic Primer (10 mL/0.33 US fl. oz.), Acrylic Liquid (14 mL/0.50 US fl. oz.), Acrylic Powder (9 g/0.33 oz.), Nail Glue (3 g/0.10 oz.)